Why not make a gun out of laminated steel plates?

Who glows?
Just say bata book, bata boom.

Name of this girl(male)?

If you didn't get her discord a while back ago its too late to talk to her....faggot

I have a giant 20 X 5 X 3 inch slab of iron
>cut into slabs
>cut slabs into shape
>drill holes through all slabs at once
>pin slabs together

Go ahead and try and see what happens

I'm not tryna slip in her(male) dms. I'm tryna find more pics of her(male)

if its 3 inches thick or even 3cm that should be thick enough you dont have to deal with layered bullshit.

How am I supposed to shape it into a bolt?

You have the internet, thus you have access to anything.

with tools
if you have the ability to cut thin pieces of metal you have the ability to cut thicker pieces of metal
same thing applies to the holes.
if you dont have any tools. thats your problem.

Attached: 1555018042396.png (700x1007, 801K)

How the hell would you make a part like this?

Attached: 1356670.jpg (800x462, 28K)

ideally with a mill

files and a drill would be an utter time consuming bitch but possible
dont pretend that would be any easier to make if it was laminated and all you had acces to was handtools. if anything it would be more work.

:/

sulky#8073
theres nowhere with pics of him other than randomly posted here

Sounds heavy

Ah. Not interested in chatting with someone I'm never going to meet desu.
Just wanna look
Thanks for the heads up though

Either cast and then machined (most likely) or machined from billet (expensive and time consumer)

Because there is no reason to. Why not sharpen all your spoons? You could, but you shouldn't.