Stovepipe city

Cokeman is the shit. Like as in the best.

*Fingers his gun* *magazine empties in a heartbeat*
Assault bump fingers should be banned

Have yet to have a failure in mine. Though the only ammo I buy is the troy landry CCI stuff.

I've literally fired ten thousand+ rounds through mine and the only malfunctions I had were due to faulty rounds.

/thread

Attached: AK-47_assault_rifle.jpg (900x332, 71K)

Attached: 1911.jpg (600x900, 58K)

>buy gun chambered in the cheapest, dirtiest round
>shoot ten thousand rounds of the cheapest, dirtiest ammo
>never lubricate or clean gun
>"I wonder why it jams so much?"

Lol this

I keep my 10/22 coated in ATF and swabbed out, jams are minimal

I actually agree with you.
I have owned a Marlin 795 for about 7+ years. I have only had a two stovepipes with that rifle.
My friend recently purchased a new 10/22, and consistently he has stovepipes and other weird FTE problems. I disassembled his rifle and polished all the wear surfaces, since it was a new firearm. It did not help his problem. I'm not sure what is up with it, but it is a jam-o-matic.
Utter garbage.

NOT A SOLJUHS GUHN?!

paul actually addresses this point in his video about the PMR-30. He talks about some boomers telling him they never had a malfunction with theirs while he watches them shoot it and have multiple malfunctions

Another idiot on /k

>>My gun sucks therefore all guns suck

Clean your gun, replace the extractor, use quality ammo.

the rifle itself is mostly fine, surprising considering the low quality and fit of the parts, the magazines are the problem. Have to be cleaned regularly and sometimes you just get a dud thats beyond saving

I’m an either
1 too stupid
2 too lazy
To clean my gun
Then it jams
Rugers jam and are unreliable

Attached: CC8358D2-6132-4E50-B07B-7567535B845E.jpg (2868x2180, 932K)

Ever occurred to you that some guns are just poorly designed?

This
OP is a fag. I never have malfunctions

TIGHT TOLERANCES

I was gifted a FDE one and CCI has been known to have spicier ammo than the rest of the group. Admittidely I only have ~600 rounds through it. But short of me intentionally limpwristing it I have yet to run into an issue with mine. Also to note I'm old school and use white lithium on anything that moves with an additional healthy dose of Hoppes oil. Does over oiling it, well compared to average, help it any? I don't douche it until it's dripping I am just liberal with my application.

10/22
In production since 1964
Over 5 million made
But OP cannot figure out how to use his properly
Yep, must be the gun.
Clean your rifle dipstick

Attached: ECA5FBBB-AD11-45DE-815F-8FA96A484DC3.jpg (1280x720, 173K)

FULL LENGTH GUIDE ROD

>cycles CCI Quiets
that's tempting

I have two 10/22s
Both work flawlessly
Must be an issue with OP
Who sounds like a little bitch.

Attached: 5F5BB9FD-6A55-4C50-9D26-6E5BFE90A708.jpg (400x349, 68K)

>der gun iz poorly designed!
meanwhile
>swears by his utter meth mouthed poverty tier savage or mossberg with a canted barrel that can't go through a single magazine
>a point of pride is what a good deal he got it for at walmart

I hadn't cleaned my 10-22 in literally years and to my utter surprise actually had a stovepipe
>then went back to shooting

I did pic related to mine and it has not stove piped since

Attached: 588440211.jpg (309x265, 28K)

too bad you've never handled a 15-22, then you could truly know what suffering is