Buying steel case "ammo"

>buying steel case "ammo"
This is the kind of shit retards with m&p15s do. Don't. Your kind will only damage the cause with your constantly malfunctioning guns.

Attached: maxresdefault (23).jpg (1280x720, 47K)

try buying guns that are not shit then talk pls. every gun that I have shoots steel just fine.

Should run lacquered steel. Either your rifle sucks, you suck at maintaining it, your gas settings are off, or some combination. Don't blame the ammo.

>this is what poor people actually believe

Attached: 69cfd3000a731e766a7f3c01661d0532.jpg (333x500, 21K)

This, I run steel case through my Shield all day, it's a bit dirty but that just means I get to spend more time cleaning my gun.

Poor
>shield
Very poor

I have literally never had a malfunction with straightwalled steel ammo, nigger

Attached: 1552462739691.png (2000x2000, 3.28M)

Who is more 'poor'?
>Person who buys shit rifle that only runs brass, can't afford cleaning supplies, and is such a wageslave they have no time for maintenance.
Or
>Person who buys steel ammo because more ammo is more ammo.
?

>Doesn't throw away guns that don't shoot steel and pick up ones that do
How do you afford any ammo on food stamps?

>another steel cased ammo user thread
>9 responses already
fuck this place

Attached: 1533479315202.jpg (600x315, 14K)

I dont run steel case in AR-15s because I dont think they are made for it, but my WASR 10 shoots them plenty fine without anything wrong. Infact I have had more problems with my AR-15 with only brass cases then my WASR-10 running only wolf steel.

>Arguing isn't fun
This place must be hell for you

The person who buys steel because he cant afford to buy lots of brass

Attached: 19093540-laughing-young-woman-eating-salad-and-watching-tv-in-kitchen.jpg (867x1300, 106K)

That's because WASR is quality gun with good military firing pin.
...and AKs are super overgassed. My saiga runs everything, sends cases into low orbit, and I'm worried about it beating itself to death.

You sound poor

I knew you'd pick that one. You're dumb and poor.
If I can afford infinite brass I can also afford double infinite steel. More ammo is more ammo.

Even if you spend $5k on cartridges you would get more ammo if it was steel.

>his AR can’t use certain ammo types

Topkek “it’s j-just as good!”

My LMT chews and spits whatever I throw in a mag. Steel, brass, doesn’t matter. If your AR won’t shoot anything without issue, it’s fucking trash.

That's good. If you're "rich" you sound retarded.

found the brass jew

>claiming to be able to afford both equally
>buys the shitty one for no reason
sounds kinda poor to me dog

Attached: salad-healthy-eating-woman-laughing-eating-food-snack-enjoying-beautiful-day-sitting-sofa-pretty-mix (957x1300, 113K)

Being illiterate =/= no reason

If you can afford to take some time off work (doubtful). You should finally learn how to read.

>buying wasr instead of arsenal

Attached: 1551728787531.gif (250x250, 993K)

>is still defending steel case instead of not being poor
I might be dumb but at least im not living in poverty

Attached: tumblr_mj0vc6bths1qg3rm7o1_400.jpg (253x380, 49K)

>not using an ak that can run steel cased black powder with stone bullets

>ak
Poor

>Buying arsenal instead of gold plated AKS74U from Sinaloa cartel

Attached: 1544424001468.jpg (1024x576, 164K)

>unironically paying more than 600 for an ak
You're buying the wrong gun.

Congratulations, your kids will be.

I like ARs too but prefer even cheapshit AKs, they're more fun to me

>LMT
HAHAHAHAHHAHAAHHAHAHHAHHAHHHAHAHHHHAH
yeah, I'd put steel case in that garbage too

this thread sucks but i find the salad eating woman meme hilarious

Well AKs certainly are easier to clean than an AR, in my experience anyway

Clean down the bore and gas tube, wipe down receiver and gas piston with a rag, done

No, no i dont think I am

Attached: tenor (13).gif (220x392, 1.06M)

The debate has reached retardation levels heretofore unknown.

ARs are cheaper than AKs you moron.

Yeah okay retard lmao I bet you vote for yang

Okay ass blasted LMT buyer.

Very true. I think my least favorite thing to do is clean the star chamber. Theres too many tight spaces in an AR and if you're trying to GI the thing it's a bitch. I've gone through hundreds of cue tips and pipe cleaners cleaning AR/M4s, AKs on the other hand I stick to a sock, a cleaning rod section, and a boresnake

Whatever, I'm out.

Where did I say they werent? I said AKs are more fun. Reading is hard, I know

Hey nigger, dont let that faggot piss you off, you're probably a better shot than him since you buy cheap ammo

>but I prefer even cheapshit AKs
Yeah okay retard lol, go back to airsoft

Pissed. no. Deeply disappointed. Yes.
The quality of the bants is just woeful.

Either samefag or pathetic poorfags

Are you trying to form some sort of argument? Because I cant fucking tell, I was an autorifleman for several years and I shoot more now that I'm out. I just fucking like AKs, they're more aesthetically pleasing to ME and they feel good to ME. I'd outshoot your noguns faggoty ass any day of the week drunk or sober

>The quality of the bants is just woeful.
I rest my case:

Not samefag, I'm the guy that likes to shoot cheap AKs

>2019
>Doesn't aware of annealing

Think whatever ya want there punkin idc

Attached: fea1a4a489f844536a3f3bda6bddf02b8bb1f782_hq.gif (368x343, 1.21M)

I’m with you, user
Take this

Attached: 447E7E06-C36A-40A9-A21B-B1624B338D82.jpg (640x554, 70K)

Explain please.

>yer poor for using steelcase
>something something dumb like it wearing a barrel or extractor or what the fuck out in a bajillion rounds

oh noes! its almost as if the cost savings r liek you can buy a whole new gun and some more by shooting steelcase!!1 IF I GET A MALFUNCTION IN MY GUN ILL FUCKING BREAK DOWN AND CRI INSTEAD OF SIMPLY TRB!!!!

LOOOOOOOL, down to my last case of wolf and have 10,000rds on the way tomorrow!!! Im shooting all the steel case I want and you can’t do shit about it so suck my DYUuuuuuck

>*PFFFFWWSSSSHHHHHHHHH*

FAGGOTS!!!!!!1

Attached: 7FACB37F-03F8-4EA2-8E13-4636894D04AE.jpg (2048x1536, 661K)

Telling people not to buy steel case because all steel is unreliable is like telling people not to buy 85 octane because it doesn't run in your ecoboost.

I actually had a recent production m&p15 sport that I could run wolf through for the first 100 rounds before lubing any of the action, it's a hit or miss

>I only buy guns because they're expensive, not because I like the look, feel, and efficacy
>I intentionally spend more money when I don't need to because I'm a shallow person who only feels good when I have the most expensive thing

this is bait. more ammo is best ammo.

My VEPR-12 throws hulls about 15 yard forward at a 45 degree angle, should I be worried?

>put $3000 worth of steel case ammo through my ar 15
>save $700 over buying brass
>buy a new barrel with the savings
FUCKING NEWFAGS WHO CAN'T INTO SAVINGS

Found the boomer

Nigger I'm 22

That's where my saiga sends all the brass like 10-15yds away. With a Vepr you can adjust the gas setting probably tune it to cycle reliably and lessen the recoil. But remember theres a huge difference between high brass slugs and low brass birdshot.
If you switch between the two alot; just leave it where it cycles both.
AFAIK one problem with AKs that you can't adjust the gas setting is that they can deform the BCG and rear trunnion over time.

I run steel through my AK (golden tiger laquer coated) and brass through my AR
I don't want to put any steel through my AR mostly because of the increased likelihood of a case breaking and getting stuck in the chamber, and wear/tear overall
AK's are built for that shit, AR's...less so
AK's are undeniably more fun to shoot than AR15's, but AR10's are more fun than both. Still won't run steel through the 10 for the same reason and steel 308 being even more likely to fuck things up.
Anyway you're all faggots

Fuck I'm just assuming you're baiting the fuck out of me at this point

Then why are you such a moaning bitch about a Chinese weed tangling forum

See

I run brass coated steel case berdan primed ammo just to ruin the brass jews deprimer.

To be fair I've been up for 24hrs and I'm a little more buzzed than I should be

I've shot 1000's of stell cased rounds through my Npap and sks wit no issues.

Cope.

>Don't.

THAT SOUNDS LIKE GUN CONTROL

ARE YOU CONTROLLING MY GUNS FAGGOT

The elf thread was better it needs to be even more inflammatory to properly work

I run nothing but steel through my M&P. Learn to take care of your rifle, dumbass.

>Cope

Attached: download_20181101_130953.png (648x680, 281K)

>yet another thread in which people call each other poor instead of actually discussing the topic

>his gun can’t run anything and everything
I’ve literally never shot a single round of steel case but I really should test it through my gun and so should you. If your gun can’t run it, your gun is literal trash and completely useless

I'll make sure to leave lots of brass plated steelcase on the range just for you, faggot.

>You are sub human if you can't afford a gun that only runs the finest of hand picked ammunition
Lmao, tulammo runs fine if you know how to take care of your weapon. Please do try to cope harder next rime.

Weapons Maintenance is legitimately the best form of meditation I've ever experienced.

Must we have this same thread every fucking day?

It wasn't like this a few months ago. I think the same loud assfaggot keeps re-posting the same tired poverty memes over and over again. There's no discussion anymore without the same characteristic fuckstick posting "lol poverty" to threads. /arg/ can't even keep their faggots in check anymore.

I shoot brass, I shoot steel. Don't really give two fucks either way. Hell, I even reload steel case, only once and you don't have to fucking trim the shit.

I think steel case is fun, but I've only put 400 rounds through my AR. I built mine for $550, didn't clean or lube it until after my last range trip, and I have yet to have any problems with Tula HP ammo. Steel seems fine for me. I wanted an AR instead of a .22, so it seems good for cheap plinking. The vodkamonkeys at Tula have done well by me so far.

Attached: 1552535190941.jpg (1022x688, 176K)

Just know that Wolf is a bit more consistent in quality than Tula but if it’s reliable, all is good. Steelcase is fucking dirty but just lube your gun.

If your properly maintained and lubricated gun simply cannot eat steel without jamming or parts breaking, your gun is shit.

Attached: brass22-660x437.jpg (660x437, 56K)

I'd believe it. I swear, the cavity size of the Tula HP varies from round to round. But it went through everything I put in it without lube, so maybe my gun is just forever hungry.

Damn webbie that was savage

God damn, is there anything better in life than shooting steelcase, getting fucked up on steel reserve, grain alcohol and watching dp porn? I feel greasy...and being greasy feels good.

Real good.

You just need a strong extractor aka not a lil bitch weak ass AR action.

14,000 rounds through my colt A4 and I'm still ringing 6" and 8" plates at 100 and 200 yards.

good enough for me

Shut up, baby. I know it.

>cleaning AKs

Attached: 1552768793091.jpg (800x533, 103K)

I've actually gotten tula hollowpoints without the hollow. It's only happened like, twice, but it was definitely what steered me away from it and towards wolf.

A quality firearm will cycle any ammo, from steel case to match grade.

Steel case ammo and bi-metal jackets require knowing literally only two things.

1. You will have carbon build up in your chamber. This probably won't mean shit to 99% person of people, but this could cause a malfunction if you swap between steel and brass frequently. So just clean your gun unlike retarded OP.

2. Bi-metal jackets will wear your barrel faster, but after 10k rounds you will save retarded amounts of money and can afford to buy a prime ass barrel. As well as you get more training for your buck.

OP, I don't know if you're trolling or retarded, possibly a mix of both, but if you were actually "rich" you would of developed an actual understanding of what it means to save money and get more bang for your buck. It's pretty obvious at this point you're just some lonely cringe retard living off of gubment, your mommy, or your girlfriend so you can spend all your money on your cool toys that you have no actual understanding of. You're the kind of guy who would probably be driving his girlfriend home, get a flat, and couldn't swap out a tire and would have to call AAA because you're so emasculated.

Attached: 1545159361112.png (665x465, 115K)

>2. Bi-metal jackets will wear your barrel faster, but after 10k rounds you will save retarded amounts of money and can afford to buy a prime ass barrel. As well as you get more training for your buck.
unlikely as bimetals are usually lacquered with a polymer that won't scratch

The powder used in the rounds causes more friction in the barrel that erodes the barrel faster. However, you can clean your rifle and prevent that buildup. Rifle barrels can last a decent number of rounds above 10k if they are properly taken care of but apparently that is not common knowledge here.

Hell I didn't even know this and will have to put some research into it. Big if true. Thanks, user.

>You're the kind of guy who would probably be driving his girlfriend home, get a flat, and couldn't swap out a tire and would have to call AAA because you're so emasculated.

Attached: 1546391802760.gif (391x365, 890K)

The fact that people browse Jow Forums with such little knowledge about guns is just sad.