The little screw at the bottom is holding the bar. Is that thick enough to put about 300 lbs on?

The little screw at the bottom is holding the bar. Is that thick enough to put about 300 lbs on?

Attached: 20180625_003819.jpg (3264x1836, 1.2M)

lose weight you fat fuck

is anything chinese up to spec?

Easily.

that looks sketch. sure there are not holes in the uprights for positive retention?

Sorry bad pic.
Marked in RED is what is holding the bar. Blue one doesn't do anything. What are the chances of a catastrophic collapse?

Attached: bar.jpg (665x1176, 164K)

As long as it's not brown people, living inside my borders, it's Up To Spec. Because - immigrants.

Take this to /diy/ my man.

I don't have room for a squat rack. Suggestions?

Attached: 1428633913885.jpg (2600x1950, 1.05M)

wait. wtf? no way the red bolt it for that

>What are the chances of a catastrophic collapse?
100%

You’re fine user

Attached: image.jpg (655x555, 181K)

Seriously, it's a death trap. Send it back to china.

That red one probably won't hold it. Why aren't you using the blue one again?

Where the fuck did you even buy this thing? Jesus Christ.

Pretty sure it's shear strength and not tensile, brotendo

It won't fit.
I fixed it though. The bottom piece is what i have on the other side, but don't have a second one of those. Middle is the bolt i used for comparison. How thick is it anyway?

Attached: 20180625_005702.jpg (3264x1836, 1.25M)

Buddy with wrists like that you’re not benching 300

This is for squats. Also nothing I can do, wrists are genetic.

I mean, I'll suck yer dick

If it's going right through then yes, easily.

Ni hao ma you yellow tinydick faggot

>Is that thick enough to put about 300 lbs on?
when burgers want to hang themselves, toplel

so what board is this thread from