Custom liquid cooling water cooling loops

Even with the heatpipe and open air? Vrms can run up to 125 degrees without issue usually. The ram is almost certainly a non factor

not him, most motherboards are designed with having a fan on the CPU running and blowing air over the VRMS etc in mind.

there's a kink in the bottom

Its on every tube, he overheated the tubes and didnt rotate them properly when bending which is ehat causes that. Its worsened if you use a bending jig

I went for dull over-compensated cooling.
So I could build and forget until clean and refill.
Though now it's only using one fan instead of 7 because I took out the old SLI.

Attached: guts.jpg (1155x1573, 1021K)

Yep they are.. No way in hell no air flow blowing across VRMs is tolerable. They're probably sucking down way more juice than they have to and burning up
The higher the temp, the more juice they suck down to regulate voltage properly.. Z370 .. you're likely OC'd.. Yeah, those bad boys are roasting for sure. I have a mild OC'd ryzen w/ air blowing on them from the circular heatsink and case fans + exhaust pulling out the heat and they still get toasty. Your shit is most definitely roasting and ram sticks get pretty hot too w/o airflow.

Mobos and components are designed for the kidn of setup you have. Its why people face the radiator airflow inward even if they have water cooling in a case.. You need some kind of airflow across the mobo and components.. 480mm rad and no dam airflow across the mobo.. smfh

Just a bad angle. I used a tube bending kit. Flow is great.

Attached: water guts.jpg (577x1024, 273K)

Your cooling solution looks like it costs more than your mobo/proc and ram.. lol

are you fucking retarded