Boils at 50c

>boils at 50c

This 3M fluid should work for pumpless liquid cooling. Why isn't it being hyped yet?

Attached: maxresdefault.jpg (1280x720, 228K)

Other urls found in this thread:

marryfucks.net/
bitporno.com/d/G00OHEZW1P
twitter.com/marryfoxreal
twitter.com/AnonBabble

>Why isn't it being hyped yet?
Because you guys only just hired a shill team to advertise it!

1. expensive as fuck
2. requires pumps for anything smaller than a 2000 gallon to circulate
3. needs to be pressurized or you get contamination from dust which is electronically conductive
4. gas is produced so it needs to be air tight but also able to expand when hot so a bladder for example like a balloon
5. every single sticker, left over flux, adhesive will fall off and become conductive
6. almost impossible to clean the board if you ever want to run it outside of oil
7. slots will fail eventually if perihperals are added after it's been soaked.
(plug in all PCI-E stuff before the initial dip to keep it sealed)
8. weight is a lot so you need a very strong tank and seals will break after a couple years so you need to get one piece tank without seals or bye bye carpet
9. oil whicking will get everywhere if not air tight, even with vertical cords
10. moisture build up on the inside from temp differentials will produce condensation which will increase electrical conductivity

i thought they tried the mineral oil thing in the past already?

>der8auer interview
someone should ask him what it's like to taste a stranger's semen in his girlfriend's pussy

these are all pretty good points, sounds like a huge pain

DerCuck

Quick rundown?

His "Girlfriend" is a pornstar and she even has Videos in the same room he ones showed
Hes a total cucklord who probably sits and whatches everything in corner

>pornstar
Big if true
Retired or still ongoing?