How do break a LAN cable without it being noticable

I need a disfuntional LAN cable. You shouldn't be able to tell it's broke from the outside.

Attached: 410gf9z6YWL._SX425_.jpg (425x425, 19K)

do a small incision and fuck up the inside

Remake the end of it, but don't push the twisted pairs in far enough, making the cable useless.
Only a trained eye would be able to tell, and doesn't require any cut marks anywhere on the cable.

i don't want to burn my place down

I assumed he didnt have the skill to do that given that he's asking at all

clear nailpolish over the pins

jizz on it

Attached: 1561259206138.gif (978x827, 1.29M)

There is no significant voltage over the wires. Even with POE, the voltage is still relatively low, meaning there is absolutely no fire risk.

I don't think that's possible. Maybe if you told us your overall goal, we could offer you a better solution.

>the voltage is still relatively low, meaning there is absolutely no fire risk.
that's not how this works

it is actually

nope.

bend a pin off the plug end

there's still plenty of risk. it's wires and eletricity.

Explain how an electrical fire occurs then.

Attached: cfk4r2rh7hu01.jpg (576x960, 60K)

remap the wires on the end

>its wires and shit, i don't gotta explain shit

excessive waste heat in a small area, near something that burns
how much heat is made through a particular conductor depends on the total power going through it, not (just) the voltage
5V/2A is equivalent to 10V/1A as far as creating heat goes

just leave it in some water overnight

to be clear, Power != Voltage
just because something is high voltage, doesn't necessary mean it's high power

You can burn the network cards like this, it happened to me.

what scam are you trying to pull?

This is the easiest & most sensible. Now fuck off

>unplug LAN cable @ work
>"dude who turned off the WiFi"

Cut it and crimp it with the wrong order

Pick the cable and bend it in opposite directions repeatedly, until the internal cables rupture. If you do it right and slow, you can break it internally without lefting any external sign.

Attached: 1525542547609.jpg (1280x720, 90K)

put both ends on a car battery and the rest in a tub of water. They give 50A if I remember it right, that should be enough to melt the wiring somewhere in the middle without burning all the sheath too badly

Attached: jeremiah.jpg (1800x900, 247K)

what about the burn marks at the ends where it sparked?

water could help you with that

Replace with patch cable.

any network card made in the last 15 years has auto mdi-x, meaning they can use a crossover or patch cable for any purpose interchangably

>lefting any external sign
>lefting

Dude

Gomenasai, engrish is harudo foru me.