Can any Amerimuts ID this bullet?

Can any Amerimuts ID this bullet?

Attached: _20190506_140226.jpg (3090x2448, 1014K)

It's one for guns

I'm pretty sure most rounds are classified via diameter, not length
and I think the usually have some info engraved on the bottom/ primer

likely 7.62×39, but not sure. Next time, try this:
-measure both the length and the diameter
-try to actually align the zero with the bottom end of the thing
-if it's for the mutts, use the inch side, they're special like that
-post on Jow Forums, not this tranny-beset shithole

it is certainly 7.62x39mm. using inch side doesnt help when the bullet is named after metric measurements

.980 caliber
Most likely for a .450 x .782 ARm70 based on its resemblance to 1998 issue NATO ammunition.

5.56x28 or possibly 5.56x45
I'll need width to confirm

I've wanted to identify this for a long time

Attached: a.jpg (960x1280, 108K)

how about you id MY bullet in your asshole

sounds very gay

the little one has a k but you can not see it in the picture

Attached: b.jpg (1280x960, 118K)

Attached: tt1.jpg (1000x1415, 219K)

Chinese steel case 7.62x39mm

It's a 7.62, where did you find that?

I was researching and the small one looks like a 12.7 × 99 mm NATO or .50 BMG

7.62x39mm my personal favorite. Superior to the 5.56 NATO round.

kek'd
dumb imperials

Its called “it will blow a person in 2”

Attached: 66CC9046-F48C-4155-8015-1F248F27D02C.jpg (1024x575, 45K)

yup, that's a bullet

Guns and bullets are pure evil, bury it so no one will find it

right probs a 30-06

kot ID