Reach reduction kit is exactly what I’m going to Get. Probably go stainless steel
Anything I’m missing?
Robert Sanders
Liam Carter
You will need a hook pick, a couple of punches, bench block or a roll of duct tape, small soft face hammer, and a small nail to trim down for use as a dummy trigger pin.
forums.brianenos.com
czfirearms.us
Those two links will get you all the information you need.
Adam Reed
Bigly.
Jaxson King
Rami is add smaller and leaves my last finger loose.
Shorter sight radius.
With extended magazine it feels good but it is still a close in weapon
Benjamin Perry
The CZ line is my personal favorite. If I were you, I would get the one with the manual safety, and replace for a SAO trigger.
C R I S P
Joseph Stewart
Why do you want a de cocker and not a safety? If you want to decock it you can just do it with your finger or whole hand. Doesn’t even decock all the way. Also, aluminum is garbage and will crack. I don’t know why manufacturers can’t make light ss guns. Don’t be a kike and use 17 and make it thin.
Leo Jenkins
CZ Aluminum frames are machined from a forging.
Steel and Stainless are cast frames.
Some slides are castings some are machined billet.
The PCR and alloy P-01 look better on the inside than my Stainless P-01.
Seriously, my Canik Aluminum L-120 frame is a better Precision casting than my SS P-01.
If I was at home I would post pictures.
If I didn't want a decocker, I would get a C100 Canik/TriStar.
At that price, $350, there are some decent polymer striker guns to be had to compare to the DA/SA CZ clone.
Anthony Green
*17-4 ss*
Luis Phillips
Safeties are useless. Change my mind.
Angel Garcia
You dont have it loaded with Underwood ammo